Glass Lining on Top of the Heater – Spare Part for Tinymight 2

Repair a broken Tinymight 2 with this Replacement Glass Lining

As careful as we are, sometimes a stray elbow, a domesticated cat, or a mistimed nudge can send your precious vaporizer hurtling toward the ground. If this happened to yours, and it’s now rattling, there’s a good chance that the Glass Lining cracked in the fall. However, all is not lost with this replacement Glass Lining that’ll get your Tinymight 2 back up and running.

Only Compatible with the Tinymight 2

Not compatible with the original Tinymight, ONLY the Tinymight 2.

Compatible with:

Tinymight 2

Instructions on how to fit:

First, you need a Torx T20 screwdriver for the big screw on the base of the Tinymight 2, to remove the bottom panel. Under the long screw hole, there’s another hole. You’ll need to use the same Torx T20 screwdriver to push it deep inside the other hole, which is under the long screw hole.

Push the screwdriver in until it reaches the inside of the top panel and unscrew the screw located there. You’ll need around fifteen full rotations to loosen this top screw. This will loosen the top panel, which will allow you access to remove the broken glass and install the new Glass Lining. When reassembling, it’s important to first screw in the internal screw, and lastly the long screw, nice and tightly.

Return policy

We only accept returns for accessories if they are within 30 days, unused and unopened, or if they are being returned with a vaporizer under our 14-day satisfaction policy.